JEDEC has published a preview of DDR6 memory, outlining modules that are smaller than DDR5 and offer higher data rates. The standards body says DDR6 is designed for data centers, with no public release date confirmed.

DDR6 RDIMMs are expected to start at 12.8 GT/s and reach “14.4 GT/s and beyond.” DDR5 tops out at 9.2 GT/s. DDR6 also expands the data bus from 64 to 96 DQ. The article notes that memory speeds can increase over a generation’s lifetime, so DDR6’s eventual maximum is not yet known.

The DDR6 module measures 74 mm, compared with 133 mm for DDR5. JEDEC says the shorter module is “intended to help accommodate higher system memory density.” DDR6 will support up to 128 GB DRAM die density, double DDR5’s figure.

JEDEC also cites improved performance per watt over DDR5, through “a change to VSS-terminated IO and data-center-focused low power modes.” Supported form factors include RDIMM, UDIMM and CAMM.

JEDEC describes DDR6 as “built for the data center,” with an interface “optimised for high-capacity modules with configurations oriented to general purpose compute as well as AI inferencing and agentic AI, which demand more capacity and performance close to the CPU.” The article says this focus does not rule out consumer use, but leaves questions about availability and affordability for PC gamers.

The article says DDR6 may arrive between 2028 and 2029, but emphasizes that the timing is uncertain and that no further release information is available.